Mac technology ltd.
MAC's idea english 
Click the photo for more information (special parts for Muratec winder)
 |
TREE PASS CUTTERS Install this scissor the favorite place if he/she has problems of enrollamiento of threads in thecircumferences of CBF. |
 |
SUPORT BRACKET FOR 7D3 Is a the base (right side) broken? It shows up a lot in it schemes it with a lifter of it carries it cone Because the cause is lack of force,it should be reinforced with this support |
 |
GATE tensor to DISK tensor Tough gate tensor is good but when the ceramic gate is damaged the quality of yarn will be lower. Especially, it is necessary to take care in expensive wool Let's remodel it to the disk type |
 |
CENTRALIZEDINVERTER changing the system from the triac to inverter of the motor of the drum guide-thread This modification it becomes simple for the change of the speed of the drum each block and it also can slowly start up the drum |
 |
CBF CAM Modification It is the prevention of the problem with this team of improvement before a long screw this broken one if a lever of CBF this wornout one |
 |
Cylinder type exit cutter Exit cutter has a lot of troubles. The waste thread coils around the motor, the gear head breaks, and cleaning is very hard to do. No more headache if it remodels it to the MAC's cylinder type. |
 |
SPLICER S2&S3CAM modification The cam of the splicer is not fixed to the shaft one by one. The S2 cam will be wore out when the use years increase and it causes defective operation of splicing. When cam has gap, let's modify to the boss type. |
 |
CERAMIC CUTTER GRIND We can grind ceramic cutters. The angle of grinding is laid down from original cutter's angle and thelack or chip of the cutter will be prevented. |
 |
AD ROLLER Because it is not made by rubber material, it is deteriorated. |
 |
SPLICER AIR GUIDE The splicer air guide made by muratec is cracks easily because it is made of the resin, and dustgoes to the cam and the cam follower. and this causes malfunction of valves |
 |
SPLICER BLOCK REPARE If you need to change the splicer nozzle block, It is good to think about reproducing the block by thismethod. The new part is very expensive for 10,000 yen or more. It ends for 1000 yen or less if it reproducesby this method. |
 |
ROTARY CUTTER DRIVE BELT Operation to which the rotational speed of the rotary cutter finds decrease end finding ratio. This belt is used to lose slipping. |
 |
SKINNY BOBBIN SENSOR How is it about the 100% detection of skinny bobbins with the color sensor The high appraisal is obtained in the link corner. |
 |
TRAY GUIDE The tray stacks on the rotary disk and this guide prevents from crowding trays. I |
 |
TURLETTE PLATE |
 |
SPECIAL KEY for C1CAM Change the key before your C1 cam is worn out. |
 |
BELT for Block type conveyer |
 |
outlet sale Just check it out! |